#
l2tp enable
#
domain default enable system
#
ike local-name h3c
#
acl number 2000
description NAT OUTBOUND ACL
rule 0 permit source 192.168.1.0 0.0.0.255
rule 10 permit source 172.16.1.0 0.0.0.255
#
domain system
authentication ppp local
access-limit disable
state active
idle-cut disable
self-service-url disable
ip pool 1 10.10.10.5 10.10.10.10
#
ike peer remote
exchange-mode aggressive
pre-shared-key simple sprig1234
id-type name
remote-name remote
#
ipsec proposal remote
#
ipsec policy remote 1 isakmp
ike-peer remote
proposal remote
#
local-user hp
password simple hphp1234
authorization-attribute level 1
service-type ppp
#
l2tp-group 1
mandatory-chap
undo tunnel authentication
allow l2tp virtual-template 0
tunnel name remote
#
interface Virtual-Template0
ppp authentication-mode chap domain system
remote address pool 1
ip address 10.10.10.254 255.255.255.0
#
interface NULL0
#
interface GigabitEthernet0/0
port link-mode route
description LAN_ZONE_INTERFACE
ip address 192.168.1.254 255.255.255.0
#
interface GigabitEthernet0/5
port link-mode route
nat outbound 2000
ip address dhcp-alloc
ipsec policy remote
#
Is this a router to router L2TP tunnel? I am looking for a way to use MSR 30-60 routers to create either an L2TP or L2F forwarding tunnel so I can get the same ip subnet at each end of that tunnel.
ReplyDeleteDoes the above do that?
The site is really beneficial for everyone to know about this topic. I think if you read blog than you will get some more information from blog. This is really useful blog.HPE MSA2040 Dual Controller
ReplyDelete